Command line Setup and Configuration – Cisco Aironet series access point

Check before you install the wireless device, make sure you are using a computer connected to the same network as the wireless device, and obtain the following information from your network administrator:

• The login and password for the access point. The default login is Cisco and the default password is Cisco (both case sensitive)
• The case-sensitive wireless service set identifier (SSID) for your radio network
• If not connected to a DHCP server, a unique IP address for the wireless device (such as 172.17.255.115)
• The access point default username is Cisco and the default password is Cisco.
• Connect putty tool to access command line.

Cisco aironet configuration.

Set SSID: Sukhesh_Wifi and Wifi Password: P@123ap2012

ap>enable

Password:

ap#config terminal

ap(config)#line vty 0 4

ap(config-line)#login local

ap(config-line)# exit

ap(config)#lin console 0

ap(config-line)#login local

ap(config-line)#exit

ap(config)#username Cisco privilege 15 password Cisco

ap(config)#hostname Sukhesh_AP

Sukhesh_AP(config)#dot11 ssid Sukhesh_Wifi

Sukhesh_AP(config-ssid)#auth open

Sukhesh_AP(config-ssid)#auth key wpa ver 2

Sukhesh_AP(config-ssid)#wpa-psk ascii P@123ap2012

Sukhesh_AP(config-ssid)#guest-mode

Sukhesh_AP(config-ssid)#exit

Sukhesh_AP(config)#int d0

Sukhesh_AP(config-if)#encryption mode ciphers aes

Sukhesh_AP(config-if)#ssid Sukhesh_Wifi

Sukhesh_AP(config-if)#Channel 1

Sukhesh_AP(config-if)#no shutdown

Sukhesh_AP(config-if)# *Mar 1 02:27:46.689: %LINK-5-CHANGED: Interface Dot11Radio0, changed state to reset *Mar 1 02:27:46.702: %LINK-3-UPDOWN: Interface Dot11Radio0, changed state to up *Mar 1 02:27:47.701: %LINEPROTO-5-UPDOWN: Line protocol on Interface Dot11Radio0, changed state to upexit Sukhesh_AP(config)#int bvi % Incomplete command.

Sukhesh_AP(config)#interface bVI
% Incomplete command.

Sukhesh_AP(config)#interface bVI 1

Sukhesh_AP(config-if)#ip address 192.168.0.122 255.255.255.0

Sukhesh_AP(config-if)#description lan interface

Sukhesh_AP(config-if)#exit

Sukhesh_AP(config)#ip default-gateway 192.168.0.254

Sukhesh_AP(config)#wr mem
^
Sukhesh_AP(config)#end

Sukhesh_AP#wr
*Mar 1 02:30:31.362: %SYS-5-CONFIG_I: Configured from console by consolemem Building configuration…
[OK]
Sukhesh_AP#